Brother Model KR-830 - Page 34

5. Mounting the bell
Name
of parts
'i'· -3
"" (!)-!
(!) Connecting pin
0 0
f ~ Conn<>ctin~ hole ® · I
c 6 6
®·2 PuUey shaft support
clamp screw •
Concave part of plllloy
®-
5.1· With push button _being kept dowo, pus the belt at once.
Fit
the belt so as to make the conoectins pio face inside.
1. On the side of the puUey, pus the belt from your side by
fittille the belt connecting pin into the concave part of
the "puUey.
2.
On the side of the clutch wheel, pasa the belt from your
side by fittina the belt coJtDeCting hole into the concave
. ..
-32 -
® -3 Pulley leaf spring
@-1
/ binding screw
Concave part of clutch wheel
]B
jo
IE
Fig. 32
· . part of the clutch wheel to connect both ends of dii ::
belt with eacll other .
. · .
.
..
5.2 Stretch the belt to such an extent as there is no slack and
5.3
~g\tten right and left clamping screw for the pulley shaft
·support.
Put ,. the !'IJ!Iey spring in the pulley shaft and fasten with the
biiRiiils screw.