56
ERROR MESSAGE LIST
CUTTER ERROR! ● This message appears if the cut-
ter did not operate correctly.
● Turn off the P-touch, and
then turn the P-touch on
again.
● If the problem cannot be
corrected, contact your
service representative.
DIVIDE BY ZERO
ERROR!
● This message appears if the
conversion rate entered when
setting up the Euro conversion
function was 0.
● Type in a conversion rate
other than 0.
EEPROM ERROR! ● This message appears if a
checksum error occurred when
the P-touch was turned on or if
the keyword was damaged and
failed to initialize.
● Contact your service rep-
resentative.
INPUT WHOLE CODE! ● This message appears if the set
number of digits is not entered
in the barcode data.
● Input the correct number
of digits or change the
number of digits set in the
barcode parameters.
ERROR MESSAGE CAUSE SOLUTION
To Next Page
Loading...
