Brother P-TOUCH CUBE PT-P300BT User Manual

NOTE
Do not set together old and new batteries. Replace all six batteries at the same time.
XConnecting the AC Adapter
If you use the optional AC Adapter:
1. Insert the AC Adapter Cord into the AC Adapter Jack on the side of the machine.
2. Insert the AC Adapter into an AC electrical outlet.
2. Install Batteries Connect the AC Adapter (cont)
CAUTION
USING A COMBINATION OF DIFFERENT BATTERIES (SUCH AS ALKALINE WITH
Ni-MH) MAY RESULT IN AN EXPLOSION. DISPOSE OF USED BATTERIES
ACCORDING TO THE INSTRUCTIONS.
CAUTION
 5HPRYHWKHEDWWHULHVLI\RXGRQRWLQWHQGWRXVHWKHODEHOSULQWHUIRUDQH[WHQGHG
period of time.
 'LVSRVHRIEDWWHULHVDWDQDSSURSULDWHcollection point, not in the general waste
stream. Be sure to observe all applicable federal, state, and local regulations.
 :KHQVWRULQJRUGLVFDUGLQJDEDWWHU\ZUDSLWZLWKFHOORSKDQH
tape to prevent it from short-circuiting (see illustration).
1. Cellophane tape
2. Alkaline or Ni-MH battery
2
1
AC Adapter
AC Adapter Cord

Brother P-TOUCH CUBE PT-P300BT Specifications

General

Model	PT-P300BT
Print Technology	Thermal Transfer
Maximum Resolution	180 dpi
Maximum Print Speed	20 mm/sec
Connectivity	Bluetooth
Mobile Device Compatibility	iOS, Android
Compatible Tape	Brother TZe tapes
Cutter	Manual
Max. Label Length	300 mm
Tape Width	3.5mm, 6mm, 9mm, 12mm
Power Source	6 AAA Batteries or AC Adapter (not included)
Mobile App	P-Touch Design&Print
Weight	380 g
Dimensions	115 mm x 115 mm x 61 mm