Brother P-TOUCH CUBE PT-P300BT User Manual

This label printer requires six (6) AAA alkaline batteries or six (6) fully-charged AAA Ni-MH
batteries, not included. As an alternative, use the AC Adapter (Optional) with this machine
and plug the label printer into an AC outlet.
2. Install Batteries or Connect the AC Adapter
CAUTION
ALWAYS USE THE SPECIFIED VOLTAGE AND THE OPTIONAL AC ADAPTER
(AD-24ESA/AD-24ESAW/AD-24ESA-01/AD-24ESAW-01) FOR THE LABEL PRINTER
TO PREVENT ANY DAMAGE OR FAILURE.
1. Hold the label printer as shown in
the illustration. Open the Battery
Cover by pressing the mark on its
side (1) and pulling in the direction of
the arrow (2).
2. Insert six batteries following the
drawing marked inside the case.
Alternate positive and negative
poles, making sure to match the
negative battery end with the coil in
the battery slot.
3. Insert the two hooks at the rear of
the Battery Cover into the slots on
the label printer (3). Push the
Battery Cover closed (4), making
sure it locks into place.
2
1
The coils are
negative pole
4
3

Brother P-TOUCH CUBE PT-P300BT Specifications

General

Model	PT-P300BT
Print Technology	Thermal Transfer
Maximum Resolution	180 dpi
Maximum Print Speed	20 mm/sec
Connectivity	Bluetooth
Mobile Device Compatibility	iOS, Android
Compatible Tape	Brother TZe tapes
Cutter	Manual
Max. Label Length	300 mm
Tape Width	3.5mm, 6mm, 9mm, 12mm
Power Source	6 AAA Batteries or AC Adapter (not included)
Mobile App	P-Touch Design&Print
Weight	380 g
Dimensions	115 mm x 115 mm x 61 mm