Brother P-TOUCH CUBE PT-P300BT User Manual

Make sure your Tape Cassettes display the TZe mark ( ).
Use only tape widths of 3.5 mm, 6 mm, 9 mm, or 12 mm.
If there is a stopper on the TZe Tape Cassette, remove it before installation.
3. Inserting the Tape Cassette
1. Hold the label printer as shown in the
illustration. Open the Cassette Cover
by pressing the mark on its side (1) and
pulling in the direction of the arrow (2).
2. Insert the Tape Cassette following the
drawing marked inside the case.
Confirm that the tip of the tape is
pointed at the Tape Exit Slot.
3. Press the Tape Cassette into the label
printer until it snaps into place.
NOTE
 $IWHUWKHWDSHSDVVHVXQGHUWKH7DSH
Guide, pull the tip to remove any slack
in the tape.
 0DNHVXUHWKHWDSHLVQRWFDXJKWLQ
the unit when inserting or removing
the Tape Cassette.
4. Insert the two hooks at the rear of the
Cassette Cover into the slots on the
label printer (3). Push the Cassette
Cover closed (4), making sure it locks
into place.
Cassette Cover
2
1
Print Head
Tape Guide
End of Tape
3
4

Brother P-TOUCH CUBE PT-P300BT Specifications

General

Model	PT-P300BT
Print Technology	Thermal Transfer
Maximum Resolution	180 dpi
Maximum Print Speed	20 mm/sec
Connectivity	Bluetooth
Mobile Device Compatibility	iOS, Android
Compatible Tape	Brother TZe tapes
Cutter	Manual
Max. Label Length	300 mm
Tape Width	3.5mm, 6mm, 9mm, 12mm
Power Source	6 AAA Batteries or AC Adapter (not included)
Mobile App	P-Touch Design&Print
Weight	380 g
Dimensions	115 mm x 115 mm x 61 mm