3. Insert the battery into the battery compartment.
4. Close the battery cover.
Removing the Rechargeable Li-ion Battery
Press and hold the (Power) button to turn the P-touch off.
Remove the battery cover and the battery, and then reattach the battery
cover.
Charging the Rechargeable Li-ion Battery
1. Make sure that the battery is installed in the P-touch.
2. Use the AC adapter and power supply cord to connect the P-touch to
an electrical socket.
Press the (Power) button to turn the P-touch on if it is not on already.
The (Battery) indicator lights in orange during charging, and it goes
off when the battery is fully charged.
Stopping Rechargeable Li-ion Battery Charging
To stop the battery charging, disconnect the AC adapter.
1. Open the top cover.
2. Pull the tube release lever up.
3. Pass the tube as shown in the illustration so that the end of the tube
reaches the “ ” mark on the P-touch, and then push the tube
release lever down.
4. Close the top cover.
1. Open the top cover.
2. Insert the ribbon cassette into the ribbon cassette compartment, and
then push down evenly until the tape cassette is installed correctly.
3. Close the top cover.
• Before use, fully charge the battery.
• Up to three hours may be needed to fully charge the battery.
1 AC adapter
2 Power supply cord
Although the charging stops if the P-touch is used to print, feed, or
perform another operation, the charging will start again automatically
after the operation is finished if the charging is not completed.
Notes on Using the Rechargeable Li-ion Battery
Before use, fully charge the battery. Do not use it before it is fully
charged.
The battery charging must take place in environments between 0°C and
40°C, otherwise the battery will not charge, and the (Battery)
indicator will remain lit. If the charging stops because the environment
temperature is too low or too high, place the P-touch with a temperature
between 0°C and 40°C and try charging again.
If the P-touch is used to print, feed, or perform another operation when
both the battery is installed and the AC adapter is connected, the
(Battery) indicator may turn off and charging may stop even if the
battery is not fully charged.
Rechargeable Li-ion Battery Characteristics
To ensure the highest performance and longest life from the battery:
Do not use or store the battery in a location exposed to extreme high or
low temperatures as it may discharge more quickly. This may happen
when using a rechargeable Li-ion battery with a high charge (90%
charged or more) in a location exposed to high temperatures.
Remove the battery when storing the P-touch for long periods of time.
Store a battery with less than a 50% charge in a cool dry place out of
direct sunlight.
Recharge the battery every six months if it is stored for long periods of
time.
If you touch a part of the P-touch while the Li-ion battery is charging, that
part of the P-touch may feel warm. This is normal, and the P-touch may
be used safely. However, if the P-touch becomes extremely hot,
discontinue use.
Inserting a Tube
• Do not use tube which is dirty, bent, flattened, has a rough surface or
uneven tube thickness, or is defective in any other way.
• When using the P-touch, position it so direct sunlight does not enter
the P-touch through the tube exit slot.
• You can use the tube half-cut adjuster to adjust the depth of half cuts
to one of three settings.
• If the tube is jammed or not cut completely, use the (Feed and
Cut) button to manually cut the tube completely. Press and hold the
button for 2 to 10 seconds until the (Power) indicator changes from
being lit in green to flashing in green, and then release it. The tube
will be cut when the button is released.
Inserting a Ribbon Cassette
To Next Page
Loading...
Need help?
General
