Brother P-touch PT-E110 User Manual

If the cutter blade becomes blunt after repetitive
use and the tape cannot be cut cleanly, rotate the
cutter board as shown in the illustration
1.
If you still have difficulties, replace with a new
cutter unit (stock no. TC-4) from an authorised
Brother reseller.
 Replacing the Cutter Unit
1. Remove the two sections of the Cutter Unit
(green) in the direction of the arrows as
illustrated below
2.
2. Install a new Cutter Unit. Push it in gently
until it locks into place.
*1 Visit support.brother.com
for the latest
information about the recommended
batteries.
Supplies and Accessories
Cassettes: See the included guide.
AC Adapter: AD-24ESA
Cutter Unit: TC-4 (replacement)
WARNING
Do not touch the cutter blade directly with your
fingers.
Specifications
Dimensions:
(W x D x H)
Approx. 109(W) X 202(D) X 55(H) mm
Weight: Approx. 400 g
(without batteries and tape cassette)
Power supply: Six AAA alkaline batteries (LR03)
Six AAA Ni-MH batteries (HR03)
*1
Optional AC Adapter (AD-24ESA)
Tape cassette: Brother P-touch TZe tape widths:
3.5 mm, 6 mm, 9 mm, 12 mm
Brother HGe tape widths:
6 mm, 9 mm, 12 mm
Cutter Board
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com

Brother P-touch PT-E110 Specifications

General

Model	PT-E110
Category	Label Maker
Print Resolution	180 dpi
Maximum Tape Width	12 mm
Keyboard Type	QWERTY
Display	LCD
Cutter Type	Manual
Print Speed	20 mm/sec
Tape Sizes	3.5mm, 6mm, 9mm, 12mm
Number of Fonts	1
Built-in Symbols	200
Multi-Block Printing	No
Memory	No
Print Method	Thermal Transfer
Tape Type	TZe tape
Font Styles	Normal, Outline, Shadow
Max. Label Length	300 mm
Weight	400 g (without batteries)
Power Source	6 x AAA batteries (LR03/HR03) (not included)