Error messages
Troubleshooting
Message Cause / Remedy
Battery
Low!
The batteries are weak.
If using AAA alkaline batteries,
replace them with new ones (do not
use a combination of old and new
batteries).
If using Ni-MH batteries, charge them
fully.
Battery
Empty!
The installed batteries are
exhausted and need to be replaced
for continued operation.
Invalid! • An invalid number was entered as
the label length, tab length, cable
diameter, flag length or faceplate
length.
• An invalid letter or number to be
incremented was selected in the
Serialize function
No Text! • You tried to print a text file when
there is no data stored in the
memory.
• is pressed when no text is
entered.
• + is pressed when no
text is entered.
•
is pressed when no text is
entered.
• or was pressed when no
text was entered while using
templates.
2 Line
Limit!
/
1 Line
Limit!
• You tried to enter a third line by
pressing .
• You tried to print or preview two
lines of text while 3.5 mm or 6 mm
tape was installed. Install a larger
tape size.
No
Cassette!
There is no cassette installed.
Install a cassette with the mark
or mark.
Message Cause / Remedy
Cutter
Pressed
The Tape Cutter Lever was
pressed in the middle of the printing
process.
Text
Full!
The maximum number of
characters (80 characters for text)
have already been entered.
Text
Limit!
Change
Length
You may have exceeded the set
tape length. Reduce the text or
select [Auto] as the tape length.
Feed OK? Tape was fed after printing when
[Chain Print] was selected. For
more information, see the Setting
Margins section.
Wrong
Tape!
Use TZe
tape
Use a cassette with the mark or
mark.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
Need help?
General
