LUBRICATION
IMPORTANT
It is important that the recommended lubrication schedule is followed.
To do so ensures a longer working life of the machine, improved reliability
and reduced operating cost.
Sleeve Type Bearings, Bushings and Wear Points, such as those listed below, should
be grease daily to flush out dirt and contaminants, to ensure sufficient clean lubrication.
• Idler Arms.
• Pivot Points.
• Cut-Off Blade Frame Shaft.
• Cut-Off Blade Support Shaft.
• RollMax Conveyor Pivot Points.
• RollMax Frame Pivot Points.
Sealed Type Bearings, should be greased sparingly every 150 hours of operation, this period
should be reduced when operating in sandy, abrasive, environments.
IMPORTANT
To avoid damage to the bearing seals, do not grease excessively.
Locations of Sealed Type Bearings :
• Crankshaft.
• 8 inch Roller.
• Conveyor Drive Shaft.
• Conveyor Idler Shaft.
• RollMax Conveyor Shafts.
• Cut-Off Cam Shaft.
• Cutter Drive Shaft.
Roller Chains.
• Oil Roller Chains Daily. Do not use grease.
See following pages for lubrication charts.
4-01
To Next Page
Loading...
