CANOPY INSTALLATION
NOTE
When the harvester is shipped on a truck, flat-bed, or trailer, the Canopy Frame is
installed onto the tractor at the factory. The Canopy has to be fitted to the frame by
the customer.
When the harvester is shipped in a container, off shore, the Canopy Fame is ‘broken
down’ and has to be assembled by the customer, installed onto the tractor and then
the Canopy fitted.
Fitting Canopy to Installed Canopy Frame. 2-6
Canopy Assembly Parts List. 2-7
Assembling Perimeter Frame. 2-8
Assembling Cross Brace Tubes. 2-8
Fitting Front Support Tubes. 2-8
Fitting Rear Support Tubes. 2-9
Installing Canopy Frame Assembly onto the tractor. 2-9/2-10
Connecting Wiring Harness. 2-10
2-05
To Next Page
Loading...
