CANOPY INSTALLATION
For machines shipped with the Canopy Frame installed on the Tractor.
For safety reasons and to prevent damage to the Canopy, the Harvester cannot be shipped/transported on a truck or
trailer with the Canopy in place, it has to be installed by the end user.
It is recommended that two persons carry out the assembly and installation of the Frame and Canopy.
NOTE
All fasteners required to assemble and install the Canopy Frame, and the Canopy, are shipped with the Canopy.
Canopy Installation.
• Remove the Canopy from the shipping container.
• Identify the ‘FRONT’ of the Canopy.
• Start with the Canopy positioned at the front
of the Frame, and unfold it completely over
the frame.
• Fold the front edge of the Canopy over the front
Tube ‘A’, and secure in place with the Zip ‘B’.
• Pull the Canopy to the rear, fold it over the rear
tube, and secure it with Zip-ties ‘C’.
• Fold the Canopy Sides over the side tubes and
secure in place with Zip-ties ‘C’.
• Fit Pockets ‘D’, over the tubes and close the Zips.
NOTE
Refer to the following pages for the assembly and
installation procedure, for machines shipped with
the Canopy Frame not assembled.
2-06
To Next Page
Loading...
