253
MIDSECTION
EXHAUST HOUSING
12
EXHAUST HOUSING
Exhaust Housing Removal
Before removing the midsection:
• The gearcase must be removed. Refer to Gear-
case GEARCASE REMOVAL AND INSTAL-
LATION on p. 271.
• The powerhead must be removed. Refer to
POWERHEAD REMOVAL on p. 215.
Remove and discard four lower mount screws.
Remove the steering arm ground lead and screw.
Remove two upper mount screws.
Remove the exhaust housing.
Remove lower mount covers and inspect the
lower mounts.
If replacement is necessary, lubricate mount with
soapy water and carefully pry at both ends to
remove.
32590
1. Ground lead (removed) 32589
1
006979
TYPICAL 23033
32578
To Next Page