35
ROUTINE SERVICE
LUBRICATION
2
Swivel Bracket and Trailering
Bracket
Lubricate the swivel bracket with Triple-Guard
grease.
Apply grease until the grease begins to flow from
the upper or lower swivel bracket areas.
Coat the pivot points of the trailering bracket with
Triple-Guard grease.
Throttle and Shift Linkage
Disconnect the battery cables at the battery.
Remove cable trunnion cover. Carefully, remove
throttle and shift cables from trunnion block.
IMPORTANT: DO NOT disturb cable trunnion
adjustments.
Shift remote control into FULL THROTTLE/
REVERSE position to fully extend the plastic cas-
ing guides.
Apply Triple-Guard grease to:
• Cable attachment pins of both the throttle and
shift levers
• Inner casings of both the throttle and shift
cables.
Shift the remote control to the NEUTRAL/IDLE
position.
Install control cables.
Check proper throttle and shift function.
Propeller Shaft
Debris from the water can become lodged around
propeller shaft. Frequent inspection can minimize
potential gearcase damage.
Remove propeller. Refer to Propeller Hardware
Installation on p. 266.
Inspect bushing and blade surfaces. Replace
damaged or worn propellers.
Clean propeller shaft. Inspect propeller shaft
seals. Replace damaged or worn seals.
Apply Triple-Guard grease to entire length of pro-
peller shaft prior to installing propeller.
Reinstall propeller hardware and propeller.
1. Grease fitting
2. Pivot points
3. Lower swivel bracket area
DR5073
1. Attachment pins, throttle and shift cables
2. Inner casings, throttle and shift cables
DRC6500GE
WARNING
When servicing the propeller, always shift
the outboard to NEUTRAL, turn the key
switch OFF, and disconnect the battery
cables at the battery.
To Next Page
Loading...
Need help?
General
