1 BASIC INSTRUCTIONS
Please follow all instructions provided with the product. We do not accept any warranty claim or
liability for damage resulting from failure to observe these installation instructions! Improper in-
stallation can cause injury and material damage!
Please note, that other installation and assembly instructions are included in other packaging units!
When these instructions are followed and all works are done properly, this will ensure a safe, energy-sav-
ing and environmentally friendly operation of the stove. Pictures shown are not to be considered as complete
presentations of any kind.
Subject to technical and assortment changes.
Report any shipping damages to the supplier immediately.
Keep these instructions.
Standards and regulations
Apart from the applicable European standards and regulations, all national or local regulations, general rules
and application notes must be observed. All applicable regulations of construction law in your country and
the legal requirements must be observed. Observe the regulations for stove operation valid in your country.
Installation
Installation must be carried out by an authorized stove-fitter, because safety and efficiency depend on proper
installation.
The floor in the room of installation must have a suitable structure and sufficient dimensions to ensure prop-
er functioning of the fireplace. The defined minimal distances must be observed during fireplace installation
(see technical data).
Ensure permanent supply of combustion air. When the fireplace is used with a separate combustion air sup-
ply connection, special attention must be paid to flow resistance. The fireplace is equipped with a nozzle for
direct connection with combustion air supply duct.
The smoke pipe connecting piece and the chimney must be suitable for the fireplace.
Cleaning possibilities for the fireplace, the smoke pipe connecting piece and the chimney must be foreseen.
All connections and openings for cleaning must ensure permanent tightness.
The total weight of the stove system can be far above 1000 kg (approx. 2200 lbs), depending on
the external cladding materials. Please observe the detailed technical data.
Please consider the massive weight of the complete stove system! If the weight exceeds the al-
lowable floor load, suitable means for load distribution must be used.
© 2021 Brunner GmbH Installation Guide KSO 33 (1.12) 3
To Next Page
Loading...