Brunner KSO 33 - TOOLS REQUIRED FOR THE ASSEMBLY OF KSO STOVE

To Next Page

To Previous Page

5 TOOLS REQUIRED FOR THE ASSEMBLY OF KSO

STOVE

Number Tools Necessary for:

1 Electric screwdriver with Phillips bit Removal of outer packaging

1 Meter stick or tape measure

1 Spirit level, at least 500mm long Levelling of base unit and pedestal

1 Knife

1 Cartridge press for 310ml cartridges High-temperature sealant application

2 Wrench for SW 13 screws and nuts Door, clamping strap and smoke pipe nozzle assem-

bly

2 Wrench for SW 22 screws and nuts Height adjustment of base unit and pedestal

1 Allen wrench for SW 2.5 screws Securing of trapezoid threaded nut while mounting

the door

1 Torque wrench (up to 10Nm) with SW5

Allen key

Mounting of cast iron front on combustion chamber

1 Torx TX 25 Fixing the door frame or mounting frame and the in-

ner front protective covers left and right.

1 Iron saw blade Preparation of outbreaks at door frame or mounting

frame

1 Half-round file Removal of sharp edges on masking covers after

breaking out the pre-punched holes.

1 Phillips screwdriver with long shaft Mounting of masking ring

1 Aluminium adhesive tape Fixing of cover blinds on top-mount accumulator

- for installation of control system parts

Number Tools Necessary for:

1 Drilling machine Drilling hole for thermocouple

1 d8 masonry drill Drilling hole for thermocouple

1 Wrench for SW16 screws and nuts Door contact height adjustment

1 Wrench for SW 17 screws and nuts Installation of thermocouple

1 SW3 Allen wrench Door contact switch installation

1 Wrench for SW20 screws and nuts Fixing the connecting cables in cable glands

Related product manuals