Description 1
12
ekr 500 web guiding controller EDV No.: MD.299.01.06 Chapter: 1
with removable control panel Date: 29.07.08 Page: 3/86
1.3 Intended use
The ekr 500 is a microprocessor-controlled web guiding controller
with removable control panel. It may be used for
• web edge guiding
(guiding to the right or left web edge)
• web center-line guiding
The web guiding controller ekr 500 has been designed to be
installed in another machine or to be integrated with other
machines to form a single system in compliance with directive
98/37/EU (Machinery Directive).
It is forbidden to commission the system until the user/operator has
determined that the machine in which the system has been
installed, complies with the specifications given in this directive.
You are only allowed to use BST web guiding systems to correct
the position of web-shaped materials (e.g. those made from paper,
film, cardboard, rubber, etc.).
The controller and the control panel must never
be installed in
potentially explosive areas.
Operation is only guaranteed if carried out using the BST web
guiding components listed in chapter 1.4.3 (“Connectable
components“).
BST web guiding systems have been designed and built in
accordance with state-of-the-art standards and the recognized
safety rules.
Nevertheless, its use may constitute a risk to life and limb of the
user or of third parties or damage the BST web guiding systems
and other equipment.
Therefore BST web guiding systems are only to be used if they are
working correctly and in a safe technical condition. Any part found
to be working incorrectly must be replaced immediately.
Only original spare parts are to be used for this. Spare parts
obtained from third parties cannot be guaranteed to comply with
the design and manufacturing conditions and safety regulations.
In this case any guarantee claims made against the BST web
guiding system will be invalidated.
Only qualified personnel who have been trained on the system are
allowed to undertake any work required on the BST web guiding
system (i.e. installation, commissioning, operation, maintenance, etc.).
Intended use also includes adhering to the instructions given in this
operating manual.
Using the machine for purposes other than those mentioned above
is contrary to its intended use. BST International GmbH does not
accept liability for any damage resulting from this type of use.
To Next Page
Loading...
Need help?
General
