Description 1
12
ekr 500 web guiding controller EDV No.: MD.299.01.06 Chapter: 1
with removable control panel Date: 29.07.08 Page: 4/86
1.4 System description
1.4.1 System structure
1.4.1.1 General
The ekr 500 consists of the controller and the removable control
panel.
The controller enclosure contains all of the control electronics and
the connections for all of the necessary web guiding components
(sensors, actuator, servo center transducer, remote control).
1.4.1.2 Controller with mounted
control panel
Controller operation is carried out via the control panel that was
attached to the front of the controller in the factory.
Controller with mounted control panel
1.4.1.3 Controller with removed
control panel
If the installation requires a remote mounting of the control panel
due to space or access limits in the machine, it can be removed
und remotely mounted in the machine operator control station.
In this case the connection between the controller and control
panel is made using a cable extension that is available as an
optional extra.
Controller with removed control panel
The length of the cable used to connect the control
panel to the controller must never exceed 20 m.
Cable extension
(2 m, 5 m, 10 m)
Controller Control panel
To Next Page
Loading...
Need help?
General
