Periodic Maintenance
© BT Industries AB 180424-040
58
Periodic Maintenance Table
Periodic maintenance
INSPECTION METHOD
I: Inspect and correct and replace as required T: Tighten
C: Clean L: Lubricate M: Measure and correct and adjust as required.
Inspection Period (Accomplish based on
operating hours or month, whichever is soonest)
EVERY 1 3 6 12 Months
EVERY 170 500 1000 2000 Hours
ENGINE
Basic components
1. Starting condition and unusual noise I ←← ←
2. Rotating condition during idling M ←← ←
3. Rotating condition during acceleration M ←← ←
4. Exhaust condition I ←← ←
5. Air cleaner element C ←← ←
6. Valve clearance M
7. Compression M
8. Cylinder head bolt T
9. Muffler rubber mount I
Blow by gas reduction device
10. Clogging and damage of PCV valve and piping I ←← ←
Governor
11. Maximum no-load stabilized ratation speed M ←← ←
Lubrication system
12. Oil leakage I ←← ←
13. Oil level I ←← ←
14. Clogging and fouling of oil filter I ←← ←
Fuel system
15. Fuel leakage I ←← ←
16. Carburetor link mechanism operation I ←← ←
17. Fouling and damage of fule filter element I ←← ←
18. Injection timing M ←
19. Injection nozzle injection pressure and condition M
20. Draining of sedimenter I ←
Cooling system
21. Radiator cooling water level and leakage I ←← ←
22. Rubber hose deterioration I ←← ←
23. Radiator cap condition I ←← ←
24. Fan belt tension and damage I ←← ←
25. Radiator rubber mount I
To Next Page
Loading...
