If you need some help, call us on 0800 145 6789* or go to bt.com/producthelp
70 Using additional handsets
You can register up to five GAP
compliant handsets to your BT
Elements 1K base to extend
your phone system without
needing to install telephone
extension sockets for each
new phone.
If a handset becomes
un-registered it will need to be
registered to the base again.
Please register this handset will
be displayed, select
OK then
follow the instructions starting
from point 4 below.
You have 2 minutes to complete
the registration process. After 2
minutes the In use light on the
base will stop flashing.
If registration isn’t successful
the first time, please try again
incase the base registration
period ran out of time.
If there are already five
handsets registered to the
base, the registration will fail.
You must de-register another
handset before you can register
the new one.
If you’ve bought a BT Elements 1K multiple pack,
any additional handsets come pre-registered to
the base. However, if you purchase an additional
handset separately, you must register it to your BT
Elements 1K base before it can be used.
Register an additional handset
1. Select Menu, scroll
to display Settings and
press Select.
2. Press
to highlight Registration and press Select.
3. Register is highlighted, press Select.
4. Press and hold Find button on base is displayed.
5. Press and hold
on the base until you hear a
beep and the In use light starts to flash.
6. Immediately, select OK on the handset. The handset
will display Registering handset to indicate the
base is in registration mode. If the system PIN is not
0000 then you will be prompted to enter it, then
select OK.
7. Once registration is successful the handset will show
Handset x registered (with X being the assigned
handset number). The handset will then synchronise
data with any other registered handsets, e.g. contacts,
speed dials, handset names and text messages.
To Next Page
Loading...
