Electrical systems – 5000 LPE 240
Parameters
Order number Date Valid from serial number T-code
225553-040 2005-05-11 723984- 660, 661, 662, 497
© BT Europe AB Service Guide LWE180, LWE200, LPE200, LPE240 10- 27
10.6.3 Service parameters
• Connect CAN-key in X41
• Press S18 and turn S17 to on at the same time.
• Press S18 until you read P= parameters.
• You have now choosen P=parameters the symbol “C” on display will
be highlighted to indicate what’s currently shown on display.
• Scroll to the parameter you want to change or look at by pressing the
L1 up or down.
• Press S18 ones to get access to the parameter.
• Set parameter value by pressing L1 up or down.
• Press S18 ones to confirm change.
• Turn S17 to off.
You have now completed a parameter change and the next time you
start the truck the new parameter setting will be valid.
NOTE !
Truck handling.
Modifying specific truck parameters will change the driving charac-
teristics of the truck.
Do not change any parameters without the necesarry know-how.
Parameter Description Unit Min
.
Max
.
Step Std
.
Description
10 PIN-code 0 9999 1 1
Facility for specifying up to 10
PIN codes (10 different drivers).
14 Crawling
speed
-10 10 1 0 The amount of power the mon-
itor should emit when you
reach the first speed sensor
can be specified here.
-10: low speed for the first
speed sensor.
10: high speed for the first
speed sensor
15 Non-config-
urable option
0 to 9
See “Option parameters” on page 29, Servicemanual
16 Configurable
option #1
See “Option parameters” on page 29, Servicemanual
17 Configurable
option #2
18 Configurable
option #3
19 Configurable
option #4
20 Hour meter
option
1 5 1 2 Select hour meter.
A
B
C
DE
To Next Page
Loading...
