BT LPE240 - Page 75

Electrical System – 5000 LWE 180/200 LPE 200
Parameters
Order number Date Valid from serial number T-code
225553-040 2005-05-11 723984- 660, 661, 662, 497
© BT Europe AB Service Guide LWE180, LWE200, LPE200, LPE240 9- 37
The parameter symbol is lit (i.e. stops flashing).
• Select independent variable #1 by activating the speed control L1.
Independent variable value #1 is displayed after 1 second.
• Press the horn button S18.
The parameter symbol flashes.
• Enter the independent variable value #1 by repeatedly operating the
speed control L1 in either direction. See the list of optional functions
in
Table 2:
• Press the S18 horn button once to confirm the new setting.
The parameter symbol is lit (i.e. stops flashing).
Adjust independent variables #2, #3 and #4 in the same way as above.
• Switch off the truck by pressing on the keypad.
The optional function is now activated.
• Check that the optional function works correctly before the truck is
put back in operation.
Table 2: List of configurable optional functions
Independent
variable #1
Independent vari-
able #2
Independent var-
iable #3
Independent varia-
ble #4
Independent variable #0 = 1: The option button controls the spider output
0:Spider 0
1:Spider 1
0:Digital output 1
1:Digital output 2
2: :Digital output 3
3: :Digital output 4
1-6:option button 1-6 Type of function:
0:instantaneous
1:butterfly switch
Independent variable #0 = 2:Reduced running speed controlled by the spider’s digital input
0:Spider 0
1:Spider 1
0-7:Digital input 1-8 0-12:reduced speed
40-100%
(i.e. 40+5*arg3 e.g.
4: 40+5*4=60%)
0:high-speed range
1:low-speed range
2: both ranges
Independent variable #0 = 3:Activate the spider output for specific movements
0:Spider 0
1:Spider 1
0:Digital output 1
1:Digital output 2
2: :Digital output 3
3: :Digital output 4
Select movements.
See
Table 3:
Initial position:
0: shines constantly
1: flashes 1 Hz
2: flashes 2 Hz