BTECH DMR-6X2 PRO - Normal Charging Tips

5
Digital DMR and Analog UHF/VHF Two Way Radio
STATUS LED
Standby(No Battery) None
Precharge Red light Flashing
Charging Red Light
Fully Charged Green Light
»
Trouble means battery is too warm, battery short-circuited or
charger short-circuited.
2.4 Normal Charging Tips
a.
Self-Test:
When powering on the charger, the red light turns on and then
turns off and stays off, which means the charger has passed the self test
and it is ready to charge the battery. If the light remains orange or the
red light blinks, it means the charger cannot pass it self-test and cannot
charge the battery.
b.
Trickle Pre-Charging:
If red light blinks when the battery is inserted
into the charger, it means that the battery voltage is low and the charger
is trickle-charging the battery (Pre-Charging Mode). The charger will
automatically turn into normal charging when the battery reaches a
certain electric charge, and if the red light stops blinking, it means the
battery voltage has reached a certain level, and the charger will charge
the battery in normal mode.
e
. LED Indicator:
2. BATTERY INFORMATION
»
Trickle charging (Pre-Charging Mode) time should not last beyond
30 minutes. If the indicating lamp still blinks red after 30 minutes
of trickle-charging, it means that the charger cannot charge the
battery correctly. Please check whether the battery or charger is
damaged.