17
Digital DMR and Analog UHF/VHF Two Way Radio
»
When in analog mode, if no signal is heard, it will emit noise when
you press the Monitor Key.
** The Rx icon is seen when monitor
is activated.
a.
Press (Menu) to enter main Menu, press / key to Settings.
b.
Select Radio Set, press, press / key to other Func to Man
Down.
c.
Select Man Down On to turn on the function.
When the function is on, the radio will start an alarm if the radio has moved
from vertical (user has fallen to ground), or dropped unit to the ground.
Raise the radio to stop the alarm. With Man Down on, do not place radio
on side in vehicle or on table or alarm will activate.
Note:
When GPS is on and positioning successfully, it will auto send out
the GPS information when the radio starts the alarm.
5.12 Man Down Alarm
5. BASIC OPERATIONS
5.13 Battery Voltage Test
Press the key programed as Voltage function to check the current battery
voltage, press this key again to return.
To Next Page
Loading...
