BTECH DMR-6X2 PRO - Status Indications; Programmed Key

10
Digital DMR and Analog UHF/VHF Two Way Radio
4. RADIO OVERVIEW
The top LED will help you to identify the current radio status.
4.1 Status Indications
LED Indication Status
Flashes Red Low battery voltage
Constant Red Transmitting
Constant Green Analog Receiving
Constant Cyan Digital Receiving
Flashes Green Scan
4.2 Programmed Key
It is possible to set different functions for [PF1], [PF2], [PF3], , keys.
Method 1: In radio Menu - Settings - Radio Set - Key - PF1, PF2, PF3, P1,P2.
Method 2: In PC software - Public - Optional Setting - Key function.
OFF No Function
Volt Check the current battery capacity voltage
Tx Power Switch the power between super high, high, middle and low power.
TalkAround Switch between Talk Around and Repeater mode
Reverse Turn on/off the frequency reverse function.
Encrypt Choose the digital encryption group for digital channel
Call
In Analog mode, send the DTMF/5TONE/2TONE encode. This
function is only valid for analog channel.
VOX Set up the VOX level
VFO / MR Switch between VFO mode and memory channel mode.
Sub PTT
Sub channel PTT, press to start the call on sub channel (NOTE: On
PF1 - PF2 - PF3 Keys Only)
Scan Press the key to start or stop scanning the channels in scan list.
FM Radio FM radio on/off
Alarm Long press the key to start alarm, short press again to exit the alarm.
Record Switch Enable/disable the recording function