16 T419S Indicator User Instructions
Operating Instructions
Using Entered Tare
To perform a net weighment using entered tare, the following steps describe a typical
operation:
1. With no weight on the scale, if the display does not read 0 press ZERO …
0 is displayed and the center-of-zero annunciator lights.
2. Key in the tare value of the container or box that will be used to hold the
material that requires a net weight value, and press TARE …
Tare weight is displayed as a negative value and the NET weight is
display and the PT annunciator lights.
3. Place the container or box and material to be weighed on the scale …
Net weight of material is displayed.
4. If repeated weighments use the same tared item, you do not need to establish
a new tare value as described in step 2.
5. To remove the tare weight from the scale, enter 0, then press TARE …
The tare is cleared and the scale is in gross weigh mode.
Using Preset Tare
Preset tares are entered in a password protected menu. Refer to details described in
the Supervisor menu on page 26. There are 10 tare values stored in memory. To
perform a net weighment using one of the preset tares, follow these steps:
1. With no weight on the scale, if the display does not read 0 press ZERO …
0 is displayed and the center-of-zero annunciator lights.
2. Press TARE …
EntEr is displayed.
3. Key in the desired preset tare number and press ZERO …
Tare weight is displayed as a negative value and the net weight is
displayed and the PT annunciator lights.
4. Place container or box and material to be weighed on the scale …
Net weight of material is displayed.
If gross weight is not at 0, press the ZERO key; then press the TARE key to clear the
tare value.
Press and hold TARE for 3 seconds and the display will show cLEArEd and the Tare
weight is cleared.
To Next Page
Loading...
Need help?
General
