What to do if my BTEK T104 won't turn on?
If the BTEK Measuring Instruments indicator won't turn on, first, check the power cord connections to ensure they are properly plugged in. If the connections are good, verify the power source is supplying electricity. Also, check if the battery is discharged and needs recharging. If none of these steps resolve the issue, service is required.
What to do if weight reading exceeds Overload limit on BTEK T104 Measuring Instruments?
If your BTEK Measuring Instruments displays a weight reading exceeding the overload limit, reduce the weight on the pan.
What to do if the weight reading is below Zero limit on BTEK T104?
If the BTEK Measuring Instruments shows a weight reading below the zero limit after powering on, add weight to the pan. If the issue persists, recalibrate the scale.
What to do if the weight reading is above Zero limit on BTEK Measuring Instruments?
If the BTEK Measuring Instruments shows a weight reading exceeding the zero limit after powering on, remove weight from the pan. If the issue persists, recalibrate the scale.
What to do if weight reading is below Underload limit on BTEK Measuring Instruments?
If your BTEK Measuring Instruments displays a weight reading below the underload limit, add weight to the pan. If the issue persists, recalibrate the scale.
What to do if I cannot zero my BTEK T104 Measuring Instruments?
To resolve the issue of not being able to zero the BTEK Measuring Instruments scale, first, remove any weights on the pan that exceed the allowable limits. Then, ensure the weight is stable by waiting for any excessive vibration or movement to stop, or increase filtering. If the problem persists, service is required, as the load cell may be damaged.
Why is the battery symbol flashing on my BTEK T104?
If the battery symbol is flashing on your BTEK Measuring Instruments, it indicates a low battery. For the T104P model, replace the dry batteries. For the T104S model, recharge the battery.
What to do if I cannot change menu settings on my BTEK T104 Measuring Instruments?
If you are unable to change menu settings on your BTEK Measuring Instruments, the Menu button may be locked. Enable the Menu button in the Menu. The LFT security switch may need to be switched off.
What to do if APW is too small on BTEK Measuring Instruments?
To solve the issue where the average piece of weight (APW) on the pan is too small (less than 0.1d) on your BTEK Measuring Instruments, replace the batch of samples with a heavier one. Alternatively, change to a scale with readability suitable for your samples.
What to do if factory calibration data is not valid on BTEK T104 Measuring Instruments?
If the factory calibration data on the load cell cable is not valid under LFT off status on your BTEK Measuring Instruments, calibrate the scale.
General| Brand | BTEK |
|---|---|
| Model | T104 Series |
| Category | Measuring Instruments |
| Language | English |
To Next Page
