T104 Series Indicators EN-19
3.4.5 Application Settings
The application can be customized for user preferences. Please refer to Application Settings section in
Weighing Mode for details about how to enter application settings.
The Check configurations are defined below (defaults in Bold).
Item Available Settings Comments
Check
On, Off To enable or disable Check
Note: You cannot disable Check if you are in the mode currently.
3.5
Totalization
Use this application to accumulate the multiple weights manually or automatically. Statistical data (the number
of samples, the total weight, the average weight, the minimum weight, the maximum weight, and the difference
in weight) is stored in memory for review and printing.
3.5.1 Application Settings
There are three totalization options:
Off ( ): disable the totalization function.
Manual ( ): press the Function button to perform totalization manually.
Auto ( ): the scale will perform totalization automatically.
Note: The default is manual.
To set the totalization option:
1. Long press the Menu button until you see . Release the button and wait for the display to show .
2. Short press the No button several times to navigate until you see , press the Yes button.
3. Short press the No button several times to navigate until you see . Press the Yes button.
4. Short press the No button several times to navigate between different totalization options. The three
options have been introduced above. Press the Yes button to confirm your selection.
5. Press the Exit button to exit.
3.5.2 Enter the Mode
1. Press and hold the Mode button until is displayed.
2. Release the Mode button.
a) If the skip function is turned off, the display shows .
If you need to clear the stored totalization result of the last time, press the Yes button, and then
start totalization.
If you need to recall the stored totalization result of the last time, press the No button to continue
the totalization of the last time.
b) If the skip function is turned on, the display enters the totalization mode directly.
Note:
Refer to section 3.6 Skip, you can find the setting of the skip function.
If there is weight on the pan, the display will show until the weight is removed or you press the
Tare button to tare.
3.5.3 Totalization Method
Manual
Place an item on the pan and press the Function button to add the weight to totalization.
Auto
Place an item on the pan. The displayed value is totalized automatically.
The flash of the icon indicates the scale has totalized the weight successfully. It will keep flashing until the
weight is removed and the pan is stable.
Notes:
The item must be removed from the pan before the next item can be totalized.
Only stable weights are stored.
When Legal for Trade is turned ON, for NTEP models, gross and net weight cannot be added to the same
total. If the first weight is recorded in gross, the future ones should be recorded in the same way. It is the
same for the net weight.
To Next Page
Loading...
Need help?
General
