26 T419S Indicator User Instructions
Supervisor menu
6 Supervisor menu
The supervisor menu allows access to the items related to the Accumulation
application. Follow the steps below to access the menu items described.
Press and hold the SETUP key until the password entry screen appears. Enter the
Supervisor password, 1793 and press the ZERO key and the screen below appears.
Highlight the item you wish to set and press the Enter key. The definitions of each item
in the Supervisor menu are described below.
SuPEr This is the top item in the Supervisor menu.
tArE This item appears only if Preset Tares are enabled. Use this to enter tare
weights for up to 10 Preset Tares.
Edit Use this to set the tare weight for Tare 1 through Tare 10.
Print Use this to print the tare list to your desired port or to the USB port.
See Printed Preset Tare report example on page 27.
rESEt Use this to clear all tares in memory.
AccuM Use this item to set the accumulation paramaters below.
Prt Tot This stands for Print Total. If enabled, during normal operation the
user can press and hold PRINT for three seconds and the selected
print format (see Tot Fmt section below) will be sent to any port
that is configured. The display will flash Prn-tot.
Tot Fmt This stands for Total Format. This is the designated print format
number used for the accumulated totals of the current active
channel. (Format 8 is the default).
Press the Enter key and the next screen appears.
The TARE item appears only if Preset Tares are enabled.
scroll up and down list then enter to select
Esc
Super
scroll up and down list then enter to select
Esc
TARE
ACCUM
If the Preset Tare list has been reset and you print the Preset Tare report the 10
memory channels will be listed but all the weights will be 0.
To Next Page
Loading...
Need help?
General
