T419S Indicator User Instructions 19
3.2 Accumulation weighing application
2. Use the keypad on the T419S to enter up to seven digits for the ID. When you
have entered the ID, press the ENTER key and the following is displayed …
SETPT key (F3)
1. Press and hold the SELECT key …
out1 is displayed followed by the current weight value for set point 1.
2. Press ENTER to accept the displayed value or key in a new value and press
ENTER to accept.
out2 is displayed followed by the current weight value for set point 2.
3. Press ENTER to accept the displayed value or key in a new value and press
ENTER to accept.
out3 is displayed followed by the current weight value for set point 3.
4. Press ENTER to accept the displayed value or key in a new value and press
ENTER to accept.
The indicator returns to the normal weighing mode
3.2.4 Performing Accumulation weighments
The accumulator application can be used to record totals of individual weighments.
Follow these steps:
1. Press ZERO to zero the scale, if necessary …
0 is displayed.
2. Place empty container on the scale and press TARE …
Net weight is displayed.
3. Place item on the scale. Press PRINT to add this weight to the accumulator
and to print the configured print format …
The PRINT annunciator lights briefly and Acc is briefly displayed.
4. Remove weight from the scale. Weight must return to inside the gross zero
band before another print and accumulation can be recorded.
kg
Gross
SETPT
CHAN ID
ID: 7841
0
Accum Chan: 5
Net Total: 0 lb
Tra n s a c t i o n s : 0
To Next Page
Loading...
Need help?
General
