Bticino 344163 Polyx Memory Display - Page 24

24
PROBLEM SOLUTION
On pressing the Entrance panel Activation/Cycling key (
) no
picture appears.
- the audio/video channel may be busy, wait for it to become free
(from 1 to 3 minutes) and try again.
On pressing the
OK key the menu does not switch on and the hand-
set gives a busy sound
- the audio/video channel is busy, wait for it to become free (from 1 to
3 minutes) and try again.
When called the handset does not ring
- check that the call has not been excluded (the call exclusion LED is
ON);
- check the configuration of the devices.
At the entrance panel it is difficult to hear the caller
- talk at a maximum distance of 40 centimetres from the Polyx
Memory Display microphone;
- check the entrance panel settings with the installer and if necessary
reduce the microphone volume;
- you can communicate in PUSH TO TALK mode (see the relevant sec-
tion).
At the handset it is difficult to hear the caller
- check the volume setting on the Polyx Memory Display;
- make sure that there are no strong noise sources near the Polyx
Memory Display;
- you can communicate in PUSH TO TALK mode (see the relevant sec-
tion).
The answering machine does not activate
- The handset is set as SLAVE and the installer has enabled the answer-
ing machine on another handset (activate the answering machine
on that handset).
2 Trouble shooting