8
3 Configuration
3.1 Manager master badge
For safety reasons, a “MASTER” badge is required, directly programmed by the installer, providing
access to the programming of the other badges (apartment master, passepartout, and residents).
To access programming mode, a master badge must be allocated to the device. Up to 20 master
badges may be saved.
The proximity reader will confirm that the badge has been accepted by means of audible signals
and the switching on of the green LED.
The transmission of an unrecognised badge, or a programming error (e.g. memory full or badge
already used), will cause the interruption of the programming procedure. This interruption is con-
firmed by a long beep, and the red LED coming on.
3.1.1 New manager master badge
1 Press and hold down the programming pushbutton
until the green LED starts flashing, and a confirmation
tone is heard.
3 The flashing of the green LED and a short beep
confirm that the manager master badge has been
saved.
2 Release the key and move the manager master
badge near the reader to save it.
Manager
master
To Next Page
Loading...
Need help?
General
