Buchi R-215 - Installing the Vacuum Controller; Cable Connections to the Rotavapor

5 Putting into operation
40 R-210/215 Operation Manual, Version B
5.9 Installing the vacuum controller
3
2
1
To install the vacuum controller on the Ro-
tavapor, proceed as follows:
Screw the holder  for the vacuum controller
to the top of the Rotavapor.
Slide the guide rail  of the vacuum controller
over the holder.
Fix the vacuum controller to the holder by
tightening the wing nut .
•
•
•
Fig. 5.12: Installing the vacuum controller
5.10 Cable connections to the Rotavapor
4
1
2
3
 Mains connection
 Communication vacuum controller / Rotavapor
 Communication vacuum pump / Rotavapor
 Communication vacuum controller / Rotavapor
Fig. 5.13: Cable connections to the Rotavapor
To make the electrical connections between the vacuum controller and the Rotavapor, proceed as
follows:
Connect the power supply  of the Rotavapor to the mains.
Connect the communication cable  of the vacuum controller to the Rotavapor .
Connect the communication cable  to the Vacuum Pump V-700 / 710.
•
•
•