Buderus 800 - Page 33

Initial start-up 2
Wall-mounted condensing gas boiler Buderus 800 - Subject to modifications resulting from technical improvements!
33
2.2.8 Fitting the boiler casing
 Put the casing in place (fig. 42, item 1).
 Close (fig. 42, item 2) and lock the clasps (fig. 42,
item 3) with the radiator key (fig. 42, item 4).
 Turn in the screw (fig. 42, item 5).
 Close the cover of the control panel (fig. 42, item 6).
Do not carry the casing by the clasps !
2.2.9 Handing over
After completing the installation and commissioning of
the system the installer should hand over to the
householder by the following actions:
 Fill out the form at the end of this manual. This con-
firms that the system is properly set up, installed and
commissioned and that it has been handed over in
good working order.
 Hand the User Manual to the householder and ex-
plain his/her responsibilities under the relevant na-
tional regulations.
 Explain and demonstrate the lighting and shutting
down procedures.
 The operation of the boiler and the use and adjust-
ment of all system controls should be fully explained
to the householder, to ensure the greatest possible
fuel economy consistent with the household require-
ments of heating. Advise the User of the precautions
necessary to prevent damage to the system and to
the building in the event of the system remaining in-
operative during frosty conditions.
 Explain the function and the use of the boiler heating
controls.
 Explain the function of the boiler fault mode. Empha-
sise that if a fault is indicated, the boiler should be
turned off and a registered local heating installer con-
sulted.
 Explain and demonstrate the function of time and
temperature controls, radiator valves etc., for the
economic use of the system.
fig. 42 Fitting the boiler casing
6
5
2
2
2
4
3
1