Buderus Logamax plus GB162-80 kW - Page 90

Actions7
Logamax plus GB162-80 kW/100 kW - Subject to modifications resulting from technical improvements!
90
IUSER INSTRUCTION
If the boiler door cannot be opened all the way, making it
difficult to remove the heat exchanger if required, you may
remove the door.
 Suspend the BC10 from the radiator as instructed in
section 68.
 Unscrew the hinge pin of the hinge [1] and remove it including
its washer.
 Pull the door upwards a bit and then pull it out of the hinge.
Carefully put the door down.
 See the Installation and servicing instructions of the boiler for
detailed maintenance information.
 Switch off the power supply to the heating system, see
section 72.
 Open the boiler door and remove the casing of the pump
group as instructed in section 73.
 Close the gas stop valve and service valves as indicated in
section 74.
 Disassemble the burner including the gas/air unit including as
indicated in section 126.
 Remove the glow ignitor and the ionization electrode as indi-
cated in section 103.
 Remove the supply, safety and return sensors as instructed
in section 95.
 Remove the pressure sensor as instructed in section 128.
 Remove the automatic air purging system as instructed in
section 125.
 Pull the condensate draining pipe down and bend it back-
wards.
 Open the 2 snap closures [1] on the left and the right and
remove the condensate water tank.
 Remove both clamp springs.
 Remove both the ground lead of the heat exchanger and the
ground lead of the ionization circuit as instructed in
section 108.
1
2
1
1