The functions4
16 Operating instructions RC20 room controller • Issue 08/2006
We reserve the right to make any changes due to technical modifications.
4.2.3 Setting the room temperature for an operating mode
that is currently inactive
You can also adjust the room temperature for an operating mode
that is currently inactive.
For example, you are currently in automatic "Day" mode and would
like to alter the night setback temperature.
Hold down "Night mode" and select the required room temperature
with the rotary selector.
The display changes from the standard display to the set night
temperature, which you can now alter.
Release the "Night mode" key. The newly selected night
temperature will be saved after approx. 2 seconds. The display
then reverts to the standard display.
Press "AUT".
The LED in the "AUT" key lights up; automatic mode is active
again.
USER NOTE
The symbol indicates that this is a temporary room setting.
The temporarily changed temperature setting is retained until you
press one of the operating mode keys (e.g. "AUT" key) or until the
heating system changes the operating mode (e.g. to night mode).
+
USER NOTE
If you are currently in automatic "Night mode", and you wish to
adjust the set day temperature, proceed as described above, but
instead hold down the "Day mode" key.
To Next Page
Loading...
