Special functions (additional menu) 9
77
We reserve the right to make any changes due to technical modifications.
Operating instructions RC30 programmable room thermostat • Issue 02/2006
Hold down the "Display" button and select the required length of
the preheat phase with the dial.
You can set a value in hours and minutes (up to max. 16:30 h:min).
In the factory setting preheating is switched off. The maximum
efficiency is obtained when the heat pump runs constantly. To
achieve this, set the length of the preheat phase so that it is longer
than the night mode period in the chosen heating program.
Release the "Display" button.
The preheat phase length is stored.
Press the "Back" button or close the flap.
+
HEAT PUMP
PREHEAT PHS
02:00
To Next Page
Loading...
