Buffalo TS1200D - Configuring a Backup Job

4 Click Add under "Off-subnet Devices", enter the IP address or hostname of the destination LinkStation or
TeraStation, and click Close.
Notes:
• To back up data between LinkStations or TeraStations on a network using jumbo frames, make sure that both
devices are configured to use identical (or similar) Ethernet frame sizes. If Ethernet frame sizes are significantly
different, the backup job may not be properly performed. In such a case, select the default frame size (1500
bytes).
• You can also specify hostname by a fully qualified domain name (FQDN).
Configuring a Backup Job
1 In Settings, click Backup.
2 Click to the right of "Backup".
63