Bunn Crescendo - Page 26

26
CLEANING
►
SEPARATING BREW CHAMBER PARTS
1. Slide cake pusher forward.
2. Pull sieve head out from brew
chamber.
4. Remove sieve head.
1
2
3
3. Remove cake pusher.
4
►
CLEANING BREW CHAMBER PARTS
1
3
Gear
Channels
2
1. Brush espresso drive gears. 3. Use brush to clean brew chamber
housing and gear channels.
2. Brush sieve head.
NOTE: Pay special attention to
the channels.
continued >
54
Cake Pusher
6
Sieve Head
5. Clean all sides of brew chamber.
NOTE: Turn gears in back of brew
chamber to clean all sections.
6. Clean cake pusher and sieve
head in warm water.
4. Use lukewarm water only to rinse
all parts.
7. Place all parts out to dry.
7