27
CLEANING
BI-WEEKLY (or Every 1,000 Cycles):
Espresso Brew Chamber (continued)
►
REASSEMBLING GROUP HEAD
32
Correct
1
Incorrect
1. Confirm all gears are aligned,
and the slots to put the sieve
head are open.
NOTE: Gap in gears should be
showing.
2. Replace cake pusher in channels. 3. Place sieve head in gear
opening, and push in.
54
4. Align cake pusher tabs into slots
on sides of sieve head.
5. Press sieve head and cake
pusher forward until seated.
►
REATTACHING GROUP HEAD TO ESPRESSO DRIVE
1
2
4
5
3
NORMAL
PRGM
RINSE
6
7
3. Connect brew chamber
outlet tube.
4 Slide red lock to right until
it locks.
5. Connect water inlet tube.
1. Place groove on lower front of
brew chamber onto mounting bar
on espresso drive.
2. Rotate the top of group head
toward rear of machine until it
snaps into place.
6. Place the NORMAL/PROGRAM/
RINSE switch in the NORMAL
position.
7. Close door.
To Next Page
Loading...
