Cruise Control is factory enabled on this e-scooter
Cruise control is engaged when in motion and the rider holds the throttle for 8 seconds
at a constant speed. The rider may release the throttle and the e-scooter will maintain
the constant speed attained when cruise control initiated.
Cruise control is disengaged by pulling the brake lever.
Disabling Cruise Control.
To disable the cruise control function: With the Busbi Wasp powered on, press the
power button 7 times in quick succession; cruise control will be disabled.
To re-enable Cruise Control, repeat the above operation.
Altered balance and handling characteristics due to additional weight.
Risk of serious injury.
Do not hang bags or items on the locking hook.
4. Riding your Busbi Wasp.
Step 1:
Before each use of the e-scooter carry out the
Pre-Use
Inspection Schedule
that can
be found in Table 1, Annex A at the end of this manual.
Step 2:
Unfold the scooter in accordance with the instructions
provided in section 3.
Press and hold the Power Button for 2 seconds located at
the top of the rear face of the handlebar assembly.
The display will initialise and then display the speedometer.
Note:
The speed setting will default to the last speed setting
in use at Power Down.
Step 3:
Once the scooter is switched on, check the
stand is folded away, place one foot on the foot
deck and then begin pushing forward on the
ground with the other foot, gaining momentum
without using the throttle.
To Next Page
Loading...
