5. Battery Charging
5.1. Battery Care and Safety.
•
Do not store or charge the battery at temperatures outside of the stated limits
(see specifications).
•
Do not puncture the battery.
•
Refer to your local laws and regulations regarding battery recycling/disposal.
•
A well-maintained battery can perform well even after many miles of riding.
•
Charge the battery after each ride to avoid draining the battery completely.
•
When used at room temperature (20 °C) the battery range and performance is
best.
•
Do not attempt to disassemble the battery.
•
Risk of fire. No user serviceable parts.
•
Do not ride when the ambient temperature is outside of the operation
temperature (see specifications), because low/high temperature will limit
the maximum power/torque. Doing so could cause personal injury or
property damage due to slips or falls.
5.2. Using the Battery Charger.
Before charging the battery, note the following:
•
Follow the instructions on the battery charger label.
•
The charger is for indoor use only.
•
Always protect the charger from rain and moisture.
•
Do not use this charger near explosive gases or corrosive substances.
•
Do not shake or hit the charger or allow it to fall.
•
The operating temperature range of this charger is between 0 and 40°C.
•
Do not attempt to disassemble the charger.
•
In the event of a fault, immediately stop using and have the unit repaired by a
•
qualified person.
•
Only use the charger supplied with your electric scooter to avoid damage.
•
When charging, the battery and charger should be at least 10 cm away from the
wall and in a dry, well- ventilated place.
•
Do not place anything in the direct vicinity of the charger during use.
•
Avoid prolonged contact with the charger while charging as the unit will become
hot to touch during normal operation.
•
Do not place the charger in an unstable position.
•
Do not cover the charger to avoid overheating while charging.
•
Do not immerse the product in water.
•
Avoid any contact with water while recharging the battery.
•
Do not use the charger with a damaged power cord or plugs.
•
Ensure the charger plug is inserted fully into the mains outlet.
•
Do not short-circuit the charger pins using a metal object.
•
Disconnect the charger from the mains power source before connecting and
disconnecting from the Busbi Wasp e-scooter.
•
The external flexible cable of this product cannot be replaced; If the cord is
damaged, the product should be discarded.
To Next Page
Loading...