6.4. Brake discs.
The Busbi Wasp is equipped with 11 cm (4.3 inch) diameter discs.
A nut and locknut system on the brake calliper allows you to adjust the cable tension
and braking force, which will vary over time according to the wear of the brake pads.
6.5. Changing the brake pads.
Brake pads are standard, replace them when they no longer have a friction component.
Remove the wheel and remove the worn brake pads from the brake calliper.
Position the new pads in the calliper so that the braking surfaces are in contact.
Do not touch the braking surfaces. Insert the brake pads one after the other into the
brake callipers. Now adjust and test the brakes.
7. Cleaning and Storage.
Use a soft, wet cloth to wipe the frame clean. Hard to remove dirt can be scrubbed with
a toothbrush, then cleaned with a soft wet cloth.
Do not wash your Busbi Wasp with alcohol, petroleum, acetone, or other corrosive
solvents. These substances may damage the appearance and internal structure of your
Busbi Wasp. Do not wash your Busbi Wasp with a power washer or hose.
Ensure your Busbi Wasp is powered OFF and the charging cable is unplugged before
cleaning; otherwise you may damage the electronic components.
Storage Temperatures
: -10 to +40°C.
To Next Page
Loading...
