3.2 Brake Cable – Fitment
•
Depress the brake lever and insert the head of the brake cable into the brake lever
bracket.
•
Thread the cable through the slot in the brake lever until the sheath fits into the port
on the brake lever.
Attention: You must pull on the sheath to perform this
operation.
•
Check the brake operation by pulling the brake lever and confirm brake calliper
movement accompanied by inability to move the scooter through pushing.
•
If necessary adjust the brake calliper see, Section 6.2
3.3 Folding and Unfolding the Busbi Wasp.
Please take time to view our helpful video by scanning the QR code found in the
introduction or by visiting:
busbistore.com/videos
The Busbi Wasp is fitted with a unique locking mechanism, providing added safety.
The method of unfolding is as follows:
Unfolding the Busbi Wasp
•
Push straight down on the rear mud
guard and hold, so as to release the
locking hook from the buckle.
•
Whilst holding down the rear mud guard,
pull the handlebar stem up and forward
until you hear the handlebar locking
mechanism engage with a ‘click’.
•
Place the scooter onto the kick stand.
Before riding the e-scooter, confirm the
Safety Pin is in the fully locked home
position.
(Red Stopper should be in contact with the
scooter frame).
To Next Page
Loading...
