5.3. Charging Procedure.
•
Open the silicone cap beneath the power switch, covering the charging port.
•
Check the charging port is dry and free from debris.
•
Insert the charger plug into the battery charging port.
•
Plug the charger's power cord into the mains port.
•
When charging, the LED on the charger will turn red to indicate proper operation.
•
When LED changes to green, this indicates the battery is fully charged.
•
Unplug the mains plug and then the disconnect the cable from the charging port.
•
Close the battery port cap.
CAUTION:
Charging for too long may shorten battery life:
•
Do not leave your Busbi Wasp connected to the charger overnight.
•
Do not charge the battery if the charging plug or socket are wet.
•
Always fully charge your Busbi Wasp battery before first use and each time you
subsequently charge it. This will maximise the service life of your battery.
•
For typical charging times: see “Battery Specifications”.
5.4. Battery
This electric scooter is equipped with a high-quality Lithium-ion battery.
Lithium-ion batteries do not suffer from memory effect and have a wide temperature
tolerance range from -10 to 40°C.
The battery is contained in a compartment under the e-scooter’s foot deck.
To maximise battery life and to protect the battery from damage, please follow the use
and care instructions below.
5.5. Battery Life
After charging your battery, it is advisable to allow 20 to 30 minutes before riding.
The operating life of your battery depends on several factors of use:
• Rider’s Speed and acceleration behaviour
• The weight of the rider.
• Gradient of riding route.
• Tyre inflation.
• Wind conditions.
• Starting and stopping frequency.
• Outdoor temperature.
5.6. General Precautions.
As memory effect is not a concern with lithium-ion batteries, it is recommended to
recharge the battery on a regular basis, or after each use.
To maximise the service life of your battery, please observe the following
recommendations:
•
Avoid very hot and very cold places (ideal charging temperature 20°C)
•
Allow the battery to cool for 30 minutes after riding your Busbi Wasp.
•
If your Busbi Wasp stops working due to overheating, place it in a cool, dry place
and wait for the battery and hub motor to cool before using it again.
To Next Page
Loading...
