•
Wear a helmet at all times when riding your e-scooter.
•
Wear appropriate footwear when using this e-scooter.
•
Your Busbi Wasp has a waterproof rating of IPX4, this means your Busbi Wasp is
protected against splashes of water.
•
This e-scooter must be properly maintained according to these instructions.
•
Carry out periodic checks as described in this manual to ensure your e-scooter is in
safe working order.
•
Read this manual carefully and ensure that you have understood all the product
information before using it.
• The e-scooter is delivered with cruise control enabled.
You are advised to engage a professional tradesman to perform maintenance on your
e-scooter every six months, to ensure it is in good working order and safe to use.
It is the owner’s responsibility to ensure that all components are in safe working order
before use.
Choose a safe place, away from traffic, to familiarise yourself with your new electric
scooter. The hub motor may start in a sudden forceful manner, check that your
handlebars are straight and that the path is clear.
Take time to familiarise yourself with riding and controlling your e-scooter to avoid a
serious accident during the first few weeks.
Ensure you are in good health before riding your e-scooter.
In case of poor weather conditions, proceed with care and adjust your speed
and reactions accordingly.
The user must comply with the requirements of national regulations when using the
electric scooter on public roads (for example, lighting and signalling).
As with any mechanical component, a vehicle is subject to high stresses and wear.
The various materials and components may react differently to wear or fatigue.
If the expected service life for a component has been exceeded, it may break
suddenly, therefore risk causing injuries to the user. Cracks, scratches and discoloration
in the areas subject to high stresses indicate the component has exceeded its service
life and should be replaced.
IMPORTANT!
For your safety:
Before each and every use, carry out the inspection schedule
described at
Annex A, Table 1
, found at the end of this instruction manual.
To Next Page
Loading...
