BUSCH VacTest - Gauge Parameter Command Reference

6 | Communication
14 / 24 Instruction Manual VACTEST DCC 400_EN_en
Gauge parameters:
Code Description DTP
400
DPP
400
DPH
400
DPC
400
DCC
400
DG Control the degas process and display the status. See chapter Degas for
more information.
x
DL DPH400 ► Configure the degas logic. See chapter Degas for more informa-
tion.
DCC400 ► Configure the cathode control logic. See chapter Ionization Sen-
sor [►15] for more information.
x x
CM
Configure the cathode control mode. See chapter Ionization Sensor [►15]
for more information.
x
ST Configure the transition between the sensors. See chapter Sensor Transition
for more information.
x x x
CC
Configure the control of the ionization sensor. See chapter Ionization Sensor
[►15] for more information.
x x x
FC
Configure the use of the hot cathode filaments. See chapter Ionization Sen-
sor [►15] for more information.
x
FN Displays which hot cathode filament is currently activated. x
FS
Displays the status of the hot cathode filaments. See chapter Ionization Sen-
sor [►15] for more information.
x
C1 Display and set the gas correction factor for the Pirani sensor. x x x x
C3 Display and set the gas correction factor for the hot cathode sensor. x
C4 Display and set the gas correction factor for the cold cathode sensor. x x
OC Scale the analog output characteristic of the gauge: consult the Busch com-
munication protocol.
x x x x x