Unboxing
10
Use a safe box knife to
open the tape holding the
carton closed.
Remove the flame photometer
Please note, for clarity the outer cardboard box is shown in a transparent state.
Remove the
2 white
accessory
boxes
Remove the white
fluid box – this
contains your
calibration fluids*.
Remove the white foam
holding the instrument in
place, this is a single piece
construction.
Remove the second fluid box
– this contains DI water and
Diluent Concentrate.
Finally remove the document
box from the bottom
We strongly recommended you retain the
packaging. Damage caused from returning the
instrument in non-BWB packaging is billed at
the normal rate.
To Next Page
Loading...
