BWB XP - Annex D: LCD Screen Breakdown; Startup, Navigation, and Ion Selection Displays

61
Annex D
LCD screen detailed breakdown
This annex gives a breakdown of a selection of the LCD menus and detailed analysis of each aspect.
XP
Flame Photometer
F4.00X32 H4.00 02.13
Initial start-up Flash Screen
Firmware, Hardware, Optic firmware
Model type
This information is also available from
the Show Info menu
Hours: 85:35
Serial No: xxxxxxxxx
F4.00X32 H4.00 02.13
1>Turn on Flame
2 Maintenance
3 Setup
Navigation
The cursor (>) indicates
position, pressing keypad
button Accept will proceed
with the selected (>) option,
move the cursor up and down
using Keypad buttons 6 & 9.
Alternatively, press the Keypad numerical button
relating to the menu option to select the option
1 Na None 5 Ba None
2>K None
3 Li. ppm
4 Ca: ppm 8 Multi
Ion selection during calibration
‘None’ indicates no existing
calibration for this element
‘ppm’ indicates the ‘Unit of
Measure’ the last calibration
was conducted in for this
element.
Single dot (.) indicates a single point calibration
was last conducted. Double dot (colon) ( : )
indicates a multi point calibration was last
conducted.