3-4 Switches 73
Hazard Warning Light Button
By pressing the hazard warning light
button, the hazard warning light button
will reset automatically, all turn signals
will start to flash, and the turn signal
indicator on the instrument and the
indicator on the hazard warning light
button will flash synchronously. Press the
hazard warning light button again; the
indicators will stop flashing.
ODO/TRIP button
■ Press the ODO/TRIP button to
switch in the circulation of ODO
- - - - TRIP A — TRIP B — ODO. In
addition, the corresponding
information switching state will be
displayed on the instrument.
■ Press and hold the button to reset
the TRIP A and TRIP B to zero.
Light Adjustment Switch Set
The light adjustment switch set consists
of the headlight adjustment switch.
Headlight adjustment switch
■ This switch is used to adjust the
beam angle of headlights
upward/downward. After low beams
are turned on, this switch can be
operated.
■ When the headlight adjustment switch is at level 0, the beam height of the
headlights is at the highest level. When the switch is at level 5, the beam
height of the headlights is at the lowest level. The driver may set the
adjustment switch to a desired level from level 0 to level 5 depending on
his/her need and the beam height of the headlights will change accordingly.
To Next Page
Loading...
