4-1 Charging Instructions 97
animation will be displayed on the combination instrument.
● In this condition, preset charging can be set via the instrument. Refer
to setting procedure of preset charging function on the combination
instrument for details.
3. Guidance on stopping charging
■ End charging:
● The charging pile will automatically end charging if the pile is set to
end charging in advance or charging is completed.
■ Disconnect the charging port connection:
● Press the mechanical lock button on the DC charging plug and pull out
the charging plug.
■ After the DC charging is completed by using a charging pile, arrange the
charging equipment, sort it properly, and place the charging plug in the
designated position of the charging pile.
■ Close the DC charging port protection cover and the charging port cap on
the vehicle.
● If the charging plug cannot be pulled out after charging, please contact the
customer service personnel in charge of the charging pile in time.
● Refer to the charging instructions for specific charging precautions.
● Refer to the charging instructions for specific charging safety warnings.
Intelligent Charging Function
The intelligent charging function will be activated if the start battery voltage is
low (insufficient power) and the power battery SOC is higher than 10% when
the vehicle is stationary so that the vehicle will automatically start the power
battery to charge the start battery to prevent the vehicle from starting failure due
to insufficient power of the start battery.
To Next Page
Loading...
